Search found 5 matches
- Tue Jul 25, 2017 4:40 pm
- Forum: Newton General Questions
- Topic: power pod calibration question
- Replies: 3
- Views: 12327
Re: power pod calibration question
Quick question, if you dial in your calibration on an ibike Newton running FW5.x with the better/best methods, but something gets bumped or gets out of whack later down the road, does the Newton self-heal the data as the Powerpod does? Just curious. Data has been pretty consistent lately for me afte...
- Mon Jul 10, 2017 5:15 pm
- Forum: Newton TT
- Topic: Angle of Newton Power Meter
- Replies: 7
- Views: 17888
Re: Angle of Newton Power Meter
I was all ticked off at my Newton yesterday with the opposite problem, as it kept showing super low watts while pushing pretty hard (by RPE and speed) on a 60mile ride with 4500ft of elevation gain. I set all kinds of segment PRs in Strava despite what appeared to be an easy Sunday spin in wattage t...
- Mon May 01, 2017 5:34 pm
- Forum: Newton Setup
- Topic: Does rider position matter during calibration ride?
- Replies: 1
- Views: 11258
Does rider position matter during calibration ride?
Is the assumption that your calibration ride will be done in your race position? The instructions say it can be leisurely, but are you calculating things like CdA on the cal ride, where I should pay attention to simulating my race position (i.e. aerobar tri position)?
- Fri Apr 28, 2017 2:35 pm
- Forum: Newton Firmware
- Topic: Is 5.0 still the most current Newton FW version?
- Replies: 2
- Views: 14212
Re: Is 5.0 still the most current Newton FW version?
Thanks, that clears it up.
- Thu Apr 27, 2017 4:02 pm
- Forum: Newton Firmware
- Topic: Is 5.0 still the most current Newton FW version?
- Replies: 2
- Views: 14212
Is 5.0 still the most current Newton FW version?
I'm confused by all the Newton 6 information. Does the Newton 6 device actually use a newer firmware version beyond FW5.x? Or is Newton 6 essentially running 5.x with an upgraded shell & wind port? I recently picked up a used Newton 4, and will be upgrading the firmware soon, once I verify every...