New AeroPod/PowerPod CdA app for Garmin devices

[Velocomp]

Is there a trick to pairing your DFPM to your PP?
I’ve tried with my Pioneer PM, and more recently with my set of Assiomas - both unsuccessfully

Your PP may need a hard reset:

1) Press-hold the button for 4 seconds
2)Once the light starts flashing, continue to hold the button for about 12 seconds
3) Eventually the light will go out briefly, then start flashing again. Release the button.

After the hard reset try a new sensor pairing. Hopefully it will work.

[Thomas]

Is there a trick to pairing your DFPM to your PP?
I’ve tried with my Pioneer PM, and more recently with my set of Assiomas - both unsuccessfully

Your PP may need a hard reset:

1) Press-hold the button for 4 seconds
2)Once the light starts flashing, continue to hold the button for about 12 seconds
3) Eventually the light will go out briefly, then start flashing again. Release the button.

After the hard reset try a new sensor pairing. Hopefully it will work.

I’ve tried resetting a few times, I can now see my HR and Speed when I select “get from device” however, no Power Meter.

I tried going on a ride, and I think the PP wanted to configure itself , I started getting power from the PP showing on my wahoo. I tried connecting sensors again whilst riding but when home, still only HR and Speed.

It’s been a few years since I used the PP regularly, but want to leverage for cda and slope

[prenard]

Please give it a try with the version 1.1.6, let me know!

Oleksiy

Hello Oleksiy. I would like to contact you. Please send me a message. Thanks. Patrick

[Velocomp]

Oleski,

It seems the frozen screen in your app is mainly related to the varia radar, when the radar get disconnected (maybe one or twice in a 50 miles ride) then the field where the CdA app is on get frozen, the rest is OK. Disconnection of the radar is reported and known and it is a problem.
The partial solution I have is I selected another field and the press the CdA field, so both locations switch and the CdA app field works again.
The other fields are not affected, but I do not have any other IQ app running and this may be a problem with IQ apps only. I will post if I find anything.

-=terry=-

You should be using the ConnectIQ app "Velocomp", which supersedes the original AeroPod app and AeroPod CdA apps.

[Velocomp]

Please give it a try with the version 1.1.6, let me know!

Oleksiy

Hello Oleksiy. I would like to contact you. Please send me a message. Thanks. Patrick

You should be using the new ConnectIQ app "Velocomp". The app written by Oleksiy is no longer supported.

[prenard]

Please give it a try with the version 1.1.6, let me know!

Oleksiy

Hello Oleksiy. I would like to contact you. Please send me a message. Thanks. Patrick

You should be using the new ConnectIQ app "Velocomp". The app written by Oleksiy is no longer supported.

I am looking information for another Oleksiy's ConnectIQ app "Rotor OCA"