wired cadence instructions
wired cadence instructions
I just bought a used Gen I ibike Pro with a wired cadence sensor. Does anyone have the instructions I can download to install it? I've got the speed sensor on and working, but thus far no luck with the cadence sensor.
Re: wired cadence instructions
Have you confirmed the position of the CAD/SPD switch in the CAD sensor assuming you have two sensors?
Try switching sensors and see if you get CAD but no SPD. One of the sensors might not be working or there could be a break in the wire.
Try switching sensors and see if you get CAD but no SPD. One of the sensors might not be working or there could be a break in the wire.
Fernando
- lorduintah
- Posts: 645
- Joined: Fri Jan 11, 2008 9:37 am
- Location: Plymouth, MN
Re: wired cadence instructions
Passing a magnet over each sensor - you should hear a click as the magnet activates the internal switch. That is another bit of troubleshooting.
Then - there is the chance that the wire is broken internally from the sensor to the mount.
Tom
Then - there is the chance that the wire is broken internally from the sensor to the mount.
Tom
Re: wired cadence instructions
Thanks for your feedback. I'll try out your suggestions.