I just bought a powerpod v3. Was very excited.
I updated firmware, setup the powerpod and did like 10 calibration rides.
Always same result. After the power went up to 100 I get blinking red light. This means the calibration ride failed.
So tried different bike with different wahoo sensors. Did a hard reset and started the process again. Same result.
This is frustrating.
In this forum los_leo had the same problem but there was no answer bto his problem
Calibration failed powerpod v3
Re: Calibration failed powerpod v3
I see that you have already made many emails to technicalsupport@velocomp.com, and that Tom has responded to you promptly.
I'm not sure why you are additionally posting here.
You are welcome to post a ride file here but I highly doubt I can provide you more assistance, over and above what Tom has provided already.
I'm not sure why you are additionally posting here.
You are welcome to post a ride file here but I highly doubt I can provide you more assistance, over and above what Tom has provided already.
John Hamann