Page 1 of 1
Labview: Memory is full (REVISITED)
Posted: Mon Sep 22, 2014 7:37 am
by andrewlees
I'm getting the "Labview: Memory is Full" message still. It seems to happen after a 0km ride ends up on the Newton. This usually occurs after a ride in the rain. Anyway, is there a fix in the works? Just wondering if it's a Newton or an Isaac thing.
I'm attaching 2 screenshots of the messages that appear.
Re: Labview: Memory is full (REVISITED)
Posted: Wed Sep 24, 2014 3:35 pm
by andrewlees
Seems that no one at Velocomp is caring too much about this issue. Hopefully the new update to Isaac will help.
Re: Labview: Memory is full (REVISITED)
Posted: Wed Sep 24, 2014 6:47 pm
by Velocomp
andrewlees wrote:I'm getting the "Labview: Memory is Full" message still. It seems to happen after a 0km ride ends up on the Newton. This usually occurs after a ride in the rain. Anyway, is there a fix in the works? Just wondering if it's a Newton or an Isaac thing.
I'm attaching 2 screenshots of the messages that appear.
Sorry, we've been a bit overwhelmed with the Newton 5 release.
I would suggest you erase your ride memory and see if that fixes the issue. The likely problem is that something in your Newton ride memory has been corrupted.