How can I change a sensor?

[Sergioperi]

Good day,

I would like to change of my main profile the HRM sensor to other HRM band . because I can't have two sensor linked, isn't it?

How could I do this? I'll do a half IRONMAN next Saturday, and i use to use a cycling hrm for training with my bike. But I have other one to run and Triatlon.

Regards!

[romi]

Hi!

Put your new HRM on you and do a new sensor pairing again. Should be enough. After that, to be sure, connect the PP to Isaac and, in your active profile, load the sensors ID from the PP (is a dedicated button in the sensors tab) to see if the old values was changed.

Stay safe and ride hard!

[Sergioperi]

Hi!

Put your new HRM on you and do a new sensor pairing again. Should be enough. After that, to be sure, connect the PP to Isaac and, in your active profile, load the sensors ID from the PP (is a dedicated button in the sensors tab) to see if the old values was changed.

Stay safe and ride hard!

Thanks a lot!!! How could I do a new sensor pairing? Do I have to press-hold botton for 4 second, and automatically PP recognize all sensors including the new HRM band (Waking up all of them previously)?

Regardsss!! And thanks again

[Velocomp]

Yes, press-hold for 4 seconds, until the light flashes. That starts a new pairing process.