Power reading too high on downhills?
Posted: Fri Apr 28, 2017 10:00 pm
Still wondering about whether my PP is calibrated correctly. Another windy ride today (I think it's been windy since receiving the device) and I'm still feeling a disconnect between PE/HR and the watts displayed. During my 28 mi O&B ride today seemed like power was much higher than PE/HR would warrant when on downhills, and on some other sections into the wind. In particular, watts went up at 8mi, 15 mi and 21 miles where my effort and HR went down. Also saw some watts reported that seemed way high for the way I was feeling.
BTW, just coming off some nasty URI crud so the last part of the ride I was pretty wiped and limped home (despite not putting in any real efforts beyond z3, with PE/HR for most of the ride z2.
PP is set to dynamic smoothing, no smoothing on the Garmin.
I did run check calibration and it suggested some changes that lowered avg and NP, but to avoid complicating things I did not accept the changes yet.
What further tuning of the profile might be appropriate?
BTW, just coming off some nasty URI crud so the last part of the ride I was pretty wiped and limped home (despite not putting in any real efforts beyond z3, with PE/HR for most of the ride z2.
PP is set to dynamic smoothing, no smoothing on the Garmin.
I did run check calibration and it suggested some changes that lowered avg and NP, but to avoid complicating things I did not accept the changes yet.
What further tuning of the profile might be appropriate?