Page 1 of 1
Profiles in replacement unit
Posted: Wed Jun 20, 2018 4:20 am
by albafar
I just received a replacement unit and thank you for that. I assume I can just export my profiles from Isaac to it without having to do any new calibration rides. Can you confirm?
Re: Profiles in replacement unit
Posted: Wed Jun 20, 2018 7:18 am
by Velocomp
You can import the profiles. I would check the first ride to make sure that calibrations look good. The first 8 minutes of your first ride may be wacky, while PP updates its internal calibration.
Re: Profiles in replacement unit
Posted: Fri Jun 22, 2018 12:30 pm
by albafar
Thanks John,
I finally made my first short test ride with the new unit. The imported profile seem to work fine. Tomorrow i might try the TT bike/profile out. But where did the Powerstroke go? Tom wrote he would install it before shipping. Did he miss out on that part or am I just blind?
Re: Profiles in replacement unit
Posted: Fri Jun 22, 2018 1:21 pm
by Velocomp
Connect your device to Isaac.
Go to Device/Unlock Feature/Get Unlock Status
You should see PowerStroke listed. If you don't please email
technicalsupport@velocomp.com
Re: Profiles in replacement unit
Posted: Fri Jun 22, 2018 5:13 pm
by albafar
Once I was blind but now I see - you made a believer out of me
Thanks John
Re: Profiles in replacement unit
Posted: Sat Jun 23, 2018 10:39 am
by albafar
I just realised the cadence sensor wasn't paired - that should help....
Re: Profiles in replacement unit
Posted: Sat Jun 23, 2018 11:00 am
by Velocomp
Once cadence is paired, PS data should re-appear.