AeroPod, PowerPod and Newton

Only today I've became aware that I shouldn't have shut my PP down for a coffee break, since it created 2 files for my ride. One before the break an one after.

Just to make sure, I want to ask if PP has to stay on during a break. I've shut it off since the bike was lifted to be parked near the site and I didn't want to mess with the calibrated sensors.

I've also noted that VeloTrack APP didn't registered the ride after the break. Despite being on all the time, I only have the tracked power of the first part of the ride.

Regarding this issue, is it possible to merge the 2 files for this ride?

Thanks!

1) Open the first ride file in Isaac

2) Use the command below to merge the files
3) After merging the files, use the command below to add full GPS data:
4) Make sure you save the merged file

Thanks for the instructions and quick reply.

So in reality, it's best to shut it off for a break if I want to move the bike around (lift it), and do the merging afterwards, right?

Cheers.

PP will put itself to sleep automatically. I don't think any manual intervention is needed.

Velocomp wrote: ↑Mon Jul 16, 2018 12:50 pm PP will put itself to sleep automatically. I don't think any manual intervention is needed.

Thanks once again!