AeroPod, PowerPod and Newton

Hi,
My PP install with firmware 6.41.


a. 1st day - completed my O&B. I set the best accuracy and follow the steps as in the instruction.
b. 2nd day - I turn on PP and pairing is done. The problem here is PP in the O&B mode again although it was completed during my first ride.

Kindly advise.

If you completed the cal ride on day one there should be a ride file afterwards. Please post that ride file.

I would do a new cal ride; please post that ride file too.

Noted.
Will post the file later.

Hi,

1. 1st O&B calibration

Hi

2. 2nd O&B calibration & ride for 80km

I think your wind sensor may be malfunctioning. Please email technicalsupport@velocomp.com for next steps. Please include ride files with your email.