AeroPod, PowerPod and Newton

Hello John,

I use the same cadence and HR sensor on all bikes. After recalibration, , some profiles did not get the HR and/or HR sensor paired. So I added the ID and type, resent the profile to the PP.

Is there a way to enable those sensors, without having to re-pair and cause a calibration ride ? If not , not a big deal as that data is contained in my Garmin.

Thank you so much.

Ken B.

If you have a profile which has all the correct IDs, then copy that profile into your other ones. Post out-and-back ride files from your other profiles and I will correct them for you.

There is no longer an easy way to type-in sensor IDs to your profile; Garmin uses 6 digits (I think) and we show only 5 digits in Isaac.

Thanks John, sounds easy enough .

Ken B.