New firmware for AeroPod and PowerPod

[Velocomp]

Firmware 9.02 improves on-the-road performance of AeroPod/PowerPod if the wind sensor becomes blocked by rain/moisture.

This firmware update is available through Isaac.

[kurt]

Hello,

Since I have installed I have the idea that my windsensor isn't working anymore.
I did a ride and there was a lot of wind and according to my powerpod there was only 8 km/h.

Do you have more input for this?


Thanks

Kurt

[Velocomp]

Please post a recent ride file.

FW will have no effect whatsoever on wind sensor operation.

[kurt]

Hello,

Ride file attached,

Thanks in advance

Kurt

[Velocomp]

Please email technicalsupport@velocomp.com. Your unit may require repair (again, this is not related to FW).

[kurt]

I hope it is not broken and requires repair. It is a very costly operation to send it to the US from Europe. I already did once for a powerpod that is only 3 years.

Reliability is apparently not the best feature of my powerpod.

[kdx200]

Hi John...iam a little confused abput the software and versions..
ive the PPv5 and firmware 10.03. is it the most updated one? is there any place to see the changelog?

also the VA is the 1.16?

thanks!

[Velocomp]

Hi John...iam a little confused abput the software and versions..
ive the PPv5 and firmware 10.03. is it the most updated one? is there any place to see the changelog?

also the VA is the 1.16?

thanks!

Oops; fair enough!!

I have changed the forum heading to "New FW for AeroPod and PowerPod."

Yes, current FW is 10.03, and VA is version 1.16