Page 1 of 1
Question about calibration ride?
Posted: Tue Oct 16, 2018 8:28 pm
by ScottChapman
How important is the location where one does the calibration ride? Does the route need to be flat(ish) with no traffic?
Can I just ride around our large(ish) parking lot?
Re: Question about calibration ride?
Posted: Tue Oct 16, 2018 8:34 pm
by Velocomp
If your calibration route has a lot of sharp turns, such as you might have in a parking lot, that is not good.
I have a 1.1 mile loop where I do calibrations. Gentle turns. That is fine.
Re: Question about calibration ride?
Posted: Tue Oct 16, 2018 8:39 pm
by ScottChapman
k, thanks!
Re: Question about calibration ride?
Posted: Wed Oct 17, 2018 9:51 am
by ScottChapman
I got a little confused during the initial setup.
If I select "Better Accuracy" it says that I can just go ride. But When I initially paired my speed sensor to the device it appeared to need a calibration?
Re: Question about calibration ride?
Posted: Wed Oct 17, 2018 10:02 am
by Velocomp
In AeroPod, a "Best Accuracy" calibration is initiated, no matter what is selected in Isaac.
Also, a calibration ride is forced whenever a sensor pairing is done.
These items are covered in the instructions.