Page 1 of 1
Power stroke sensor location DFPM
Posted: Fri Nov 23, 2018 12:32 am
by GooseRider
Hi,
I am using my Aeropod with a Power2max NG Eco DFPM. Cadence info also comes from the DFPM. What sensor location should I choose for powerstroke?
Thanks,
Morten
Re: Power stroke sensor location DFPM
Posted: Fri Nov 23, 2018 6:49 am
by Velocomp
Above the chain stay.
Re: Power stroke sensor location DFPM
Posted: Mon Nov 26, 2018 2:27 am
by GooseRider
Thx!! BTW. why is the wasted energy so much lower with the AeroPod compared to what I was used to with the PowerPod? Usually my wasted energy with the AeroPod is less than 1-2 watts.
Morten
Re: Power stroke sensor location DFPM
Posted: Mon Nov 26, 2018 6:23 am
by Velocomp
PowerStroke works only when there is a crank-mounted cadence sensor on your bike. DFPMs that transmit cadence do not enable PowerStroke.
Re: Power stroke sensor location DFPM
Posted: Mon Nov 26, 2018 12:47 pm
by GooseRider
John,
Thank you for the clarification. Does the CdA function benefit from the Hidef sampling rate or is it only used for Powerstroke? Just wondering if I should change to 1 sec sampling.
Thanks,
Morten
Re: Power stroke sensor location DFPM
Posted: Mon Nov 26, 2018 12:59 pm
by Velocomp
CdA is not used with PowerStroke.
At present there is no way to switch data recording to 1 sec intervals...
Re: Power stroke sensor location DFPM
Posted: Wed Nov 28, 2018 2:48 pm
by GooseRider
BTW just a suggestion. If Aeropod/Powerpod is used with DFPM and no cadence sensor, then Isaac shouldn't show wasted watts to avoid confusion ...
Morten
Re: Power stroke sensor location DFPM
Posted: Wed Nov 28, 2018 4:34 pm
by Velocomp
A good suggestion; I will see if we can do this!