Nuovo AeroPod
Posted: Sat Jul 17, 2021 7:27 am
Hi everyone, after using an old Newton for a few weeks, I have decided to buy a new AeroPod.
Today I made the first outing with the newcomer and I would like to know if the steps I have taken are correct.
1) I connected AP to the PC, waited for it to load (red light off) and went to profile 4 where I only entered my weight and that of my equipment and set the most accurate calibration;
2) I paired the cadence and speed sensors and the Garmin 830 with the latest firmware
3) For calibration, I woke up my sensors, turned on AP and finally turned on the Garmin. I went on a road with good asphalt and started the calibration. AP flashed red / green, before leaving I pressed the button and the light turned yellow, on the Garmin the watts started from 0 to 50, the light is now red I turned around and at this point the light returned to yellow, so I went back to the starting point where I pressed the button again.
I expected AP to continue increasing watts up to 100 to finish its measurement but instead it turned off the light and sent data to the Power, Slope fields on my Garmin.
4) I noticed that the Cda value remained stationary at 0.354, probably because I unintentionally interrupted the calibration (I ask for confirmation) and no wind data was ever displayed even if I see it detected on ISAAC;
Last questions:
Can you turn off AP manually? Or does it turn off on its own after some time (as I imagine) after how long?
Battery life, how many hours?
I attach the file of the total stroke, the one of the calibration I think is the initial part.
After downloading the race I realized that I hadn't set the date and time ...
Is there a manual in Italian? My AP has firmware v.8.02 where can i see the release notes?
Greetings Ciro and thanks for every answer.
Today I made the first outing with the newcomer and I would like to know if the steps I have taken are correct.
1) I connected AP to the PC, waited for it to load (red light off) and went to profile 4 where I only entered my weight and that of my equipment and set the most accurate calibration;
2) I paired the cadence and speed sensors and the Garmin 830 with the latest firmware
3) For calibration, I woke up my sensors, turned on AP and finally turned on the Garmin. I went on a road with good asphalt and started the calibration. AP flashed red / green, before leaving I pressed the button and the light turned yellow, on the Garmin the watts started from 0 to 50, the light is now red I turned around and at this point the light returned to yellow, so I went back to the starting point where I pressed the button again.
I expected AP to continue increasing watts up to 100 to finish its measurement but instead it turned off the light and sent data to the Power, Slope fields on my Garmin.
4) I noticed that the Cda value remained stationary at 0.354, probably because I unintentionally interrupted the calibration (I ask for confirmation) and no wind data was ever displayed even if I see it detected on ISAAC;
Last questions:
Can you turn off AP manually? Or does it turn off on its own after some time (as I imagine) after how long?
Battery life, how many hours?
I attach the file of the total stroke, the one of the calibration I think is the initial part.
After downloading the race I realized that I hadn't set the date and time ...
Is there a manual in Italian? My AP has firmware v.8.02 where can i see the release notes?
Greetings Ciro and thanks for every answer.