Search found 4 matches
- Wed Jun 15, 2011 9:38 am
- Forum: iBike Dash Setup
- Topic: Not recording ride!
- Replies: 1
- Views: 3080
Not recording ride!
This morning I plugged in my iPhone and was asked to update the firmware, which I did successfully. However, it now doesn't display or record any readings. All sensors are present and correct. Screenshots below: http://img.skitch.com/20110615-dn1u5kmbe6dcay5gb36qs2wah4.jpg http://img.skitch.com/2011...
- Thu Jun 02, 2011 1:50 am
- Forum: iBike Dash Setup
- Topic: Battery Options
- Replies: 4
- Views: 5192
Re: Battery Options
If you look at the battery, it has + and - markings. These indicate the battery contacts that line up with the contact springs in the battery compartment. You'll need to connect the wires to the same points on the board that the contact springs connect. Soldering to the springs will be problematic a...
- Wed Jun 01, 2011 12:34 pm
- Forum: iBike Dash Setup
- Topic: Emailing ride file
- Replies: 1
- Views: 3142
Emailing ride file
It seems that the .ibd ride file is not compatible with WKO+ 3.0 Build 48, or am I missing something?
Please could you make the file emailable (if there's such a word), in CSV format too?
Please could you make the file emailable (if there's such a word), in CSV format too?
- Sun May 29, 2011 5:14 am
- Forum: iBike Dash Setup
- Topic: Battery Options
- Replies: 4
- Views: 5192
Re: Battery Options
Having looked at the eWorks device I can see no reason why not. It's output can be adjusted to 3.7V to match the Dash battery.
However, as stated above, the integrity of the booth would be compromised.
However, as stated above, the integrity of the booth would be compromised.