AeroPod, PowerPod and Newton

Rode in the rain and water got in my ibike (visible in screen) and stopped working. Put it in a bag of rice which dried it out and all is fine now. Suggestions on how to waterproof??

Can I send my Gen 1 profile to my new Gen III ibike or do I have to do a new calibration including the 4 mile O&B? Also, same question regarding pairing to wireless?

That did it. HR now reads "Paired". Got to love your customer service and from the "top dog" no less

1st of all I do not always ride with my HR strap so I go into "set up" and turn off the HR. When I want to ride with HR, I go back into setup and try to turn it back on. When I do this I only get two options "find" & "none". I do not get "HR Paired". I the...

The last 2 times I rode the unit failed. A lot of moisture is inbetween the unit and the mount causing the unit to fail. I can't imagine how it's getting there unless the unit itself is leaking. Any thoughts...

While riding in Lake Tahoe (6,000 - 7,000 feet) my power is off 10% to 15%. Could be the lack of oxygen but I was wondering if a high altitude coast down would yield adjusted numbers...Any comments.

Thanks John, it's nice to see that you guys still monitor the forums.

Done, thanks T.

I finally got a chance to see how the new wireless worked in wet weather. It is much better. However, in a heavy heavy downpour the ibike did fail. The problem was solved by drying the area between the mount and the bike.

I emailed myself individual ride files while I was in Hawaii but I am unable to open them with the ibike software at my main computer "cant handle file format #9". I can open them in Cpeaks however. Any suggestions.

can you or someone elaborate on the mount issue. The mounting issue is limited to 4 possibilities: 1. bad or no sticky tape on bars 2. bad or no stick on mount 3. mount not cranked down to the max 4. combo of 1-3 I'm not sure about the new wireless mount but on the older wired mount the top of the ...

As Richard pointed out it may be the mount to the handelbar but it could also be the mount itself. I had this problem with the older wired mount. Try tapping on the front of the ibike and than the rear of the ibike. The tilt should change initially but return to the pre tapped setting within a few s...

When replacing battery should I replace the battery in the mount also? i.e. will they both drain at the same rate.