AeroPod, PowerPod and Newton

The click versus hold certainly appears to be the issue.
With click to start the unit worked perfectly. After flashing green it went to straight green then registered accurate watts immediately.
Thanks as always for your quick response.

Michael

John I think that you may have nailed it. I have been holding the button until it starts blinking, roughly for seconds, next ride I will simply touch that button and wait. That would be so awesome if it solves the issue. You are correct the unit is rock solid once under way. I'll let you know what h...

Hi John, Here are files from todays ride. I also noticed the date is wrong (that is a new thing). As has been the case since I got the unit roughly 30 seconds in the PP went into calibration modes, so I did the out and back and carried on for my ride. The unit works fine solid signal and numbers tha...

My PowerPod V5 goes into calibration mode every single ride. I have tried swapping sensors, resetting the entire unit, clearing out previous profiles, extracting profile from both the unit and from individual rides. To date nothing has worked. My work around has been to simply schedule 5 to 10 minut...

Hi John,

I am out of town for a bit so won't have a chance to post those likely til early next week.

Thanks,

Michael

Hi John, Setting it in Issac. And just click on the PP button, not the click and hold. Whenever I have switched the profile and click on the PP button, it goes to yellow and then the flashing green red as if I have planned to do a new out and back. Am I correct in assuming that when I set active pro...

I havent seen this directly addressed anywhere (apologies if it has been covered) I have a Garmin Speed sensor along with a Cadence sensor that can be moved from bike to bike. I have created three profiles based on three different bikes. Each of these 3 profiles use the same speed and cadence sensor...