AeroPod, PowerPod and Newton

Perhaps this feature already exists on the Newton (or in Isaac)... Any chance that a new field could be added to the summary screens that displays a maximum average power output for a ride over a given time interval, ideally 20 minutes? This would enable a "fitness" test as part of every r...

On this morning's ride (attached), Newton didn't seem to be reading the headwind properly. When there was an obvious strong headwind, Newton read around a 2 mph tailwind. The tailwind readings seemed to make sense. For the most part, there didn't seem to be much of a crosswind. I stopped several tim...

This morning, I took my Newton out on her maiden voyage. Prior to starting the ride, I did a successful tilt calibration in my garage. During the ride, I stopped and did a wind calibration prior to starting the CAL ride. When I loaded the CAL ride into ISAAC, and did a "check calibration",...

Mount looks great! How can I take advantage of the pre-shipment special order (before 5/1/12) with the Garmin GT capability AND specify this new mount? Perhaps I missed the configuration on the Website... Will the website be updated to include the handlebar and stem mount option? I am not interested...

Any thoughts on how the "suspension" component of Trek's new Domane will impact the Newton's performance?

Mounting the Seca lights upsidedown won't work since the light lenses aim the beam down and across, effecitvely chopping off the top of the beam. Unfortunately, there isn't any more space on the bars to increase the spread bewteen all the gear. Not sure I undersandthe Bento box remark... I'll setup ...

Your comment about the wind is exactly what I observed (generating 3000-4000W did seem superhuman). I've also found that descending at higher speeds also causes problems.

Hopefully others will chime in....

I do quite a bit of riding with lights and would like to understand the "calibration" impact of using the same profile both with and without lights. I've attached a photo showing my command and control center with the iBike and the lights mounted. The front of the iBike is about 1 cm forwa...

Is this bug also present in R4.21?

After redoing the calibration and tilt, the power meter now reads very high (over 1000W) for the first mile or so.

With regard to the second problem, there are still several times when the power shows 0 when pedaling under load.

Thanks! It worked perfectly.

2 quick newbe questions - 1. When using my iSportGT, for the first mile or so of my ride, the power numbers displayed are very low. Is this a normal response from the device? 2. On a couple of rides, the power numbers go to zero immediately on descending through a thermal gradient where the temperat...

I just started using my iSport GT. The data displays in real-time on the Garmin, and I am able to upload the data into Garminconnect and Training Center. However, when I upload the data into Cyclops' Power Agent software, I get the following error " One or more rides were recorded using a varia...