AeroPod, PowerPod and Newton

Attached are instructions that describe how to perform a wireless scan.

A new Scan is required whenever a wireless sensor battery is changed or whenever a new bike is set up.

Note that these instructions apply only to Gen III iBikes.

I'm stumped how to do this. I hold down the top and bottom arrows at the same time (tried about 20 times) but it will never do a scan. Only ever goes into setup. I'm guessing this means I'm not quite pressing them right, but I just can't do it! Any other way to initiate a scan?

Thanks
Gerrard

Go into setup and click the up arrow until you come to a screen that says "REL". What is the number beneath it? This is your firmware version.

Note that the Scan procedure works only with Gen III iBikes, with firmware 4.17 or higher installed.

Thanks John I thought I had upgraded the firmware but it was still only 3.x. Apologies for that. All good now.