AeroPod, PowerPod and Newton

I understand that the gen 3 head unit has 2 profiles for two bikes but I am confused on how this works in conjunction with the SW.

I had a very bad profile in "profile 1" that essentially made me look like Alberto Contador. On the same bike I set up profile 2 and got great data. I did this because I was on my winter bike and it was destined to become "profile 2" anyways.

Now for the big question. When I am using the SW and "accept profile & send to ibike" where did the new profile get stored in the head unit? "Profile 1? Profile 2? or Both?

When sending a profile to the iBike Gen3, it goes into the profile that is currently active. So... go to setup ? Set Prof, then hit the center button. Whatever number it says at that point is the current profile.

If you want to send a profile to the other profile, then hit the up or down arrow to go to your other profile then hit the center button and exit setup.

Thanks Fernando, you are absolutely right!