Page 1 of 1
A question on tilt
Posted: Sun Sep 28, 2008 1:27 pm
by cjonbike
I ride a recumbent so I can not see the iBike while I am riding. I have a good profile. If I do not care what the numbers read while I am riding, can I go out and ride without doing a Tilt Calibration and get good data when I get back and do the Post Processing on the computer?
Thank you in advance for all input
Chris
Re: A question on tilt
Posted: Sun Sep 28, 2008 1:45 pm
by coachboyd
Yes, the software will correct the tilt afterwards. If you don't see the unit at all on the bike, then this is going to be the best option.
Just make sure that the front of the iBike has a good clean view of the wind (nothing in front that could cause an air wake or block wind from entering the unit)
Re: A question on tilt
Posted: Sun Sep 28, 2008 1:59 pm
by cjonbike
Coach Boyd
Thanks so much for your help.
Chris
Re: A question on tilt
Posted: Sun Sep 28, 2008 2:32 pm
by coachboyd
No problem, and a question for you.
What is your cda on the recumbent?
Re: A question on tilt
Posted: Sun Sep 28, 2008 8:55 pm
by cjonbike
I ride a trike and the CDA is .456
Thanks again
Chris