Solid Yellow Light will not Calibrate on second bike

[j4ese]

Hi

I am having trouble pairing second bike.

I have watched your video and done everything correct and my main bike is fine, I do have separate cadence for second bike and have not used my main bike for a couple of days which is in the garage so it could not pick up sensor off that bike.

I sent Prof3 to bike paired ok the Garmin 1000 head unit has paired with the Powerpod for second bike and flashes green then solid green to show it’s paired.

When I turn powerpod on its shows solid yellow but when I go for a ride which I have done 6 times today to calibrate it just stays solid yellow and does not flash or countdown.

I also did a reset for 10 seconds and set Prof3 back to factory settings in case I was doing something wrong and resent to Powerpod but I just get the same solid yellow and nothing happens.

The name Powerpod on the unit’s level so i dont think its a tilt problem.

Any thoughts

[Velocomp]

It's likely that your speed sensor is not sending a signal.

PowerPod will show solid green if the cadence sensor is working. With you bike at rest, spin the wheel of your bike to confirm that the speed sensor is operational.

[j4ese]

Hi

Forgot to say Speed was showing fine. Cadence and speed showing on Garmin ok.

Thanks

[Velocomp]

You can see speed on Garmin even if speed sensor is not working; GPS speed will be shown.

Please check by rotating wheel as advised.