O&B calibration not working

[eeyore]

Hi

I have followed your guide to O&B calibration to the letter, but it is not working (tried it 6 times today). Once the counter reach 100, it will flash red for a while end then flash red/green and start counting from 1 again, in stead of showing actual power. I have tried to hard reset the unit several time, but the result is the same. During the calibration run, the flashing LED is according to your guide.

Attached is the latest course and my profile. I notice that there is no wind data in the course file, perhaps I have a broken device?

[Velocomp]

I am sorry about your problem!

There is no wind sensor data in your ride file; this is what is causing the failed O&B ride.

Please contact technicalsupport@velocomp.com for next steps.